Coil trim spacers to suit Pajero Generation 3 & 4 rear upper 20mm lift pair KUN26 aluminium uvp The factory supplied bash plates

The factory supplied bash plates and guards weigh kg

lightest and best designed bash plates available

High tensile recessed bolts supplied

25mm thick 6061 T651 aircraft grade 242MPa -- machined easy care finish

Designed and manufactured in Australia

Coil trim spacers to suit Pajero Generation 3 & 4 rear upper 20mm lift pair KUN26 aluminium uvp The factory supplied bash platesPair of rear upper coil trim spacers to suit Pajero Generation 3 and 4, all variants. Spacers are 10mm thick which gives approximately 20mm of lift. Made in Australia. Machined from Aluminium alloy. Is the front of your Pajero too high for the rear, or is the rear too low for the front, and you don't want to change the coil stiffness? Are you going to load it extra heavy for a trip then want to put the suspension back to the way it is?